| View previous topic :: View next topic |
| Author |
Message |
rod
tinkerer
Joined: 14 Apr 2003
Posts: 380
|
 Posted: Sun Jun 01, 2003 4:28 am Post subject: where is the... |
 |
|
| ...oil pressure sending unit hole on the G200??? |
|
| Back to top |
|
 |
Gene FJ20DET
hod rodder
Joined: 06 Oct 2001
Posts: 9163
Location: brisbane
|
| Posted: Sun Jun 01, 2003 11:51 am Post subject: Re: where is the... |
|
|
driverside of the ending towards the front, down low near the sump. (i think thats the oil press sender)
_________________
 |
|
| Back to top |
|
|
tx1975
tinkerer
Joined: 21 May 2002
Posts: 321
|
| Posted: Sun Jun 01, 2003 2:01 pm Post subject: Re: where is the... |
|
|
| yup thats it, if that hole buggered get an adaptor plug and any hole down there has oil press i think, |
|
| Back to top |
|
|
champo
rice boy
Joined: 09 Dec 2002
Posts: 26
|
| Posted: Sun Jun 01, 2003 5:15 pm Post subject: Re: where is the... |
|
|
| yeah, thats it, drivers side, bottom of block, just above sump. any hole works, I just did it with mine, keep in mind thogh, that heat causes the grub screw plugs to lock in there sometimes, so be careful, good luck. |
|
| Back to top |
|
|
rod
tinkerer
Joined: 14 Apr 2003
Posts: 380
|
| Posted: Sun Jun 01, 2003 11:29 pm Post subject: Re: where is the... |
|
|
ok sweet az!
from that point it will be going too the top off the turbo...
and from the bottom off the turbo, has anybody got some good recomendations where that should go on the engine? |
|
| Back to top |
|
|
rod
tinkerer
Joined: 14 Apr 2003
Posts: 380
|
| Posted: Mon Jun 02, 2003 5:29 pm Post subject: Re: ??? |
|
|
| .... |
|
| Back to top |
|
|
|
