Ben Wight

[Gene FJ20DET]

"And sold a heap of carbs, but I've still got heaps left. People tend to want 32/36's more than bigger carbs like a 34ADM, so i've only got 2 DGV's left."

what carbis do u have left?
how much? what condition? the fit the gem manifold or need a different one?? i have a single lynx side draft manifold will they fit that>?
_________________

[Ben Wight]

Hey Gene, below is my last ad. Any of the sidedraughts will bolt onto your lynx manifold. All weber DOCE's, Dellorto DHLA's and Solex side draughts share the same stud pattern.

Re-advertising again because I want to get rid of more bits before packing them away again.

I've got a heap of carbs to sell. All are completely stripped, cleaned thoroughly and partially reconditioned with new gaskets, diaphragms and needle's and seats where needed, and a complete clean out of all passages, etc.

DOWNDRAUGHT WEBERS (all share same stud pattern as 32/36, and can be bolted onto standard inlet manifold with adaptor plate). Adaptor plates are $40 to suit down draught webers and come with all bits needed to bolt on the carb.

34 ADM (mechancial secondaries) from XE/XF falcon - $85

32/36 DGV (mechancial secondaries) off 2 litre escort - $85

also 1 x Holley 350cfm (not same as weber)

SIDEDRAUGHT CARBS (all share same DCOE stud patter, no manifolds included, I dont have any!)

2 x 40mm Dellorto side draughts, DHLA straight off alfa, - $300 inlc. linkage to synchronise both carbs butterflies.

1 x Solex 40mm side draught - $85 - looks same as side draught dellorto or weber, runs well.

I also can put together a complete bolt on kits for the weber downdraughts, with everything needed, even including ported inlet manifolds as per my website, if wanted.

www.giant.net.au/users/wight

Manifolds are $110, (TX ones are $130 as has bigger ports)

Throttle brackets are $10 to suit downdraught webers.

If anyone is keen, let me know. My eamil is wight@giant.net.au

Ben Wight

[BuddyTD]

What area are u from? Have you got twin 48mm downdraughts? How much?