Analogue clock

[PinkBitz]

i have a tf, and i just obtained me a excellent condition dash, that has a analogue clock where my useless vaccum guage used to be. theres no wiring for it, can someone tell me how to wire the thing up,

cheers,

[PinkBitz]

see what happens when you block people..............no replys.............

[Stock TE]

Just plug the dash in normally and it should work, there is no difference between the clock, vacuum or tacho dash connections.

[PinkBitz]

yeah there is.... the vaccum hose. hehehehe.
hope it works,
cheers,

[PinkBitz]

what about the male plug on the back of the clock. normal connections only light up the clock. does the male plug on the back of it have anything to do with the clock actually workin.

[ByteMe22]

i the back on my dashes (tx & tc) the clock has two wires with ring terminals on the end which get screwed down onto the board to give it power. if you like i will take a photo with my digital camera tonight and post them up for you

[Gene FJ20DET]

yeah, i did a similare change to what u are doing, u need to plug that male thinggy into a constant power, just run a wire from ya fuse box to it. piece of piss.
theres ya 1st straight answer heehehe
have a good one, gene
_________________

[ByteMe22]

if you are doing that you may as well look for a constant supply on the dash itself because then if you want to take it out again you dont have wires going everywhere... and it just makes a neater job...

[PinkBitz]

does the interior light wire near the steering colomn have enough voltage.

cheers fellas,

[Gene FJ20DET]

acant see why not
_________________

[PinkBitz]

sweet. all wired up now.