HotGemini.com - Holden Gemini heaven
Home What's New About Help Contact




porting a head

 
Post new topic   Reply to topic    hotgemini.com Forum Index -> Gemini R&D
View previous topic :: View next topic  
Author Message
HOTHOUSE GREEN GEMI
tinkerer


Joined: 19 May 2003
Posts: 148

PostPosted: Thu Sep 25, 2003 10:01 pm    Post subject: porting a head Reply with quote

ok a technique i used and shall i say anyone diy your head should take note if u are following whats in the work shop add this to it when finished porting your head slide you valves back up (make sure you blow the guides out first and oil them use some patrolium jelly and smear some on the valve seat be carefull with this not to go out side the port this will put your reading out. Now make sure your valves and tight and atleast liquid tight. Not get and acurate messureing cylinder and fill to 100ml with metho or petrol. Now DONT SPILL ANY IF YOU DO START OVER. Fill your first port and measure how much fluid you use for each port the point to this is to try and even the port out as much as possible even size even gas flow or vapor flow You can use this or not but atleast you know you head ports are the same size
Back to top
View user's profile Send private message Send e-mail
Display posts from previous:   
Post new topic   Reply to topic    hotgemini.com Forum Index -> Gemini R&D All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group
© HotGemini.com 2000-2007 | Privacy Policy | Terms of Use | Site Map