GENE

[GemiNick]

how much do you reckon its cost you to do your car? and how much would it cost just for a normal fj20t conv?

cheers

[rust3]

if i remember correctly, he said it owns him 12000 as is, but dont take my word for it.

fj conv depends on a few things.. how much u pick the motor up for, if you do the work yourself, any mods etc

[Gene FJ20DET]

owes me so far about $15K sould be on the road at about $20K (HOPFULLY :S)

if u just wanted a engine conversion i would say $5000-$6000 including the motor and box and u doing all the work yaself. that stock

------
post form a while back for a stock conversion (basic prices, could be more could be less depending on who u know and who u blow i guess )
---------
fj20-
not including the cost of the box. to put it in stock i would say have $4000 ready to flush.
but as u go im sure u will speind more.

VERY quick run down (these are cheap prices, may cost more, but not less)

engin and box - $1500
bigger fuel lines - $100
surge tank - $100
bigger fuel pumps - $200
rising fuel reg' - $200
custom mounts - $150
custom gearbox mounts - $150
hydrolic clutch peddle - $200
custom rear sump - $200 - $300
custom oil pick up - $150
custom exhaust manifold (stockone hits the fire wall)- $600
brake upgrade - $450

(im sure somethings will cost a bit more and somethings u may find cheaper but that all adds up to $4100)

then im sure if your getting a custom manifold u will get a bigger turbo. and im sure u will want a FMIC. so thers another $1500-$2000 ontop.

+ engineering- $1000ish (4 engin, gearbox, FMIC and brakes)
+ insurance - easy over $1000
+ rego - $500ish

iv done/doing everything myself except the intrior triming
_________________