| View previous topic :: View next topic |
| Author |
Message |
Loz
backyard mechanic
Joined: 05 Oct 2001
Posts: 943
|
 Posted: Thu Mar 06, 2003 12:49 pm Post subject: Someone with a rotor conversion |
 |
|
I just bought an 808 wagon(very heap and will have the roof chopped of to be a summernats cruiser) with an unfinished 13B conversion in it. Its a twin dizzy engine and I want to know how to wire up the coils when going to the single coil 808 setup. Parrallel, series, something else??
Cheers
Loz |
|
| Back to top |
|
 |
WAY2LOWatwork
tinkerer
Joined: 02 Apr 2002
Posts: 188
|
| Posted: Thu Mar 06, 2003 12:51 pm Post subject: Re: Someone with a rotor conversion |
|
|
13b's arent twin dizzys!
dodgy |
|
| Back to top |
|
|
Loz
backyard mechanic
Joined: 05 Oct 2001
Posts: 943
|
| Posted: Thu Mar 06, 2003 1:13 pm Post subject: Re: Someone with a rotor conversion |
|
|
Oops my bad. I meant to write twin coil. Any ideas?
Loz |
|
| Back to top |
|
|
WAY2LOWatwork
tinkerer
Joined: 02 Apr 2002
Posts: 188
|
| Posted: Thu Mar 06, 2003 2:24 pm Post subject: Re: Someone with a rotor conversion |
|
|
TRY THIS.
i think mine is set up like so.....
run a 12v power source to the coils, thru a relay or ignition, this can be bridged between both coils.... then the negatives connect to the distributor. 1 is going to be leading and the other trailing. connect them to the points so that they fire at the right times. then connect them with the leads to the dizzy, make sure the leading coil goes to the correct 1, same as the trailing.
this might help, a bit vague, but ill check properly when i get home |
|
| Back to top |
|
|
cni
tinkerer
Joined: 25 Sep 2002
Posts: 72
|
| Posted: Thu Mar 06, 2003 3:21 pm Post subject: Re: Someone with a rotor conversion |
|
|
also u might wanna go ask at like www.3rotor.com on the forum there or www.badrotor.co.nz in there forum they have a pretty good tech section and they should be able to give more advice!!!!!
Mazda 808's r the shiznits....... |
|
| Back to top |
|
|
|
