34 ADM Webers VS others, disadvantages, FITING IT?

redgem · tinkerer Joined: 17 Apr 2002 Posts: 368

ok i read ben wights site, that is the best resource for webers! i can get the Weber 34 ADM for free, these are the ones off the falcons, so i want to use this one,
are there any other points i need to know to try and fit this???
are there any disadvantages???

how much would another (better) weber cost???

can i fit it without having the whole engine out???

what is the best weber to get??? keeping in mind i eventually want to run a turbo set up or supercharger...

thanks alot

rob_w · tinkerer Joined: 19 Feb 2002 Posts: 395

the other webers are costly, unless you know someone...

ok, the only way to run the 34 adm is off the 32/36 adaptor plate, but remove all of the studs in the manifold, and the adaptor plate, and use studs from the falcon manifold, as the other ones are way too short.

then, unless you are running a workerd 2ltr [or as i am told], youll have to re-jet it.
i had one as a gas tb, and out of neccecity had to run it on ulp with the 4.1ltr jets in it, on a stock 1600.
ran well on idle and wot, but not in between.
ben reckons that it should be good for a turbo setup.[34 adm]
hope this helps some.
rob.